Electrical Interconnection - Hifonics Thor Series Owner's Manual

Class a/b 6-channel amplifier with dsp processor
Hide thumbs Also See for Thor Series:
Table of Contents

Advertisement

Available languages

Available languages

1
BEFORE CONNECTING
For the professional installation of a sound system, car audio retail stores offers appropriate wire kits. Ensure a sufficient profile section
(at least 25 mm
), the suitable fuse rating and the conductivity of the cables when you purchase your wiring kit. Clean and remove rust-
2
streaked and oxidized areas on the contact points of the battery and the ground connection. Make sure that all screws are fixed tight after
the installation, because loose connections cause malfunctions, insufficient power supply or interferences.
FUSE
1
The inserted fuses protect the amplifier from shorts and capacity overload.
GND
2
Connect this GROUND terminal with a suitable contact ground point on the vehicle's chassis. The ground wire must be as short
as possible and must be connected to a blank metallic point at the vehicle's chassis. Ensure that this ground point has a stable
and safe electric connection to the negative "–"pole of the battery. Check this ground wire from the battery to the ground point
if possible and enforce it, if required. Use a ground wire with a sufficient cross section (at least 25 mm
the plus (+12V) power supply wire.
REM
3
Connect the turn-on signal (e.g. automatic antenna) or the turn-on remote signal of your head unit with the REM-terminal of the
amplifier. Use therefor a suitable cable with a sufficient cross section (0,5 mm
head unit.
BATT+12V
4
Connect the BATT+12V-terminal with the +12V pole of the vehicle's battery. Use a suitable cable with a sufficient cross section
(at least 25 mm
) and install an additional in-line fuse. For safety reasons the distance between the fuse block and the battery
2
should be shorter than 30 cm. Do not set in the fuse into the fuse block until the installation is accomplished.
LOGO
5
This push button switches the logo illumination on the upper side from blue to white.
INSTALLATION INSTRUCTIONS

ELECTRICAL INTERCONNECTION

2
3
4
5
) and the same size like
2
). Hereby the amplifier turns on or off with your
2
23

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Trx6006dsp

Table of Contents