Drain Quench Assembly - Jackson AJ-64CE Installation/Operation & Technical Manual

Drain Quench Assembly

06401-002-44-07
Nipple, 1-1/2" NPT
04730-207-40-00
Modified Compression Fitting
05700-001-16-52
Reducer, 1-1/2" x 1/4"
04730-002-55-76
To Dishmachine Drain
Tee, 1-1/2" x 1-1/2" x 1-1/2"
04730-011-69-93
Reducer, 1-1/2" to 1/2"
04730-002-55-75
From the existing drain, attach the two additional Tees using the 1-1/2" NPT Close Nipples. Tighten the Reducers into the Tees
as shown above. Attach the Modified Compression Fitting into the 1-1/2" to 1/4" Reducer. Position the bulb of the thermostat
so that it rests approximately 1/4" from the bottom of the Tee. Tighten the Modified Compression Fitting as required. Attach to
the incoming cold water line. Use pipe dope or thread tape as required to prevent any leaks.
SECTION 5: PARTS SECTION
DRAIN VALVE HANDLE ASSEMBLY/DRAIN QUENCH SYSTEM
Valve, Check, 1/2"
(Not Shown)
04820-002-55-77
Drain Valve Handle
Sleeve
05700-000-01-53
Handle Weldment
05700-021-70-45
Nipple, Close, 1/2" NPT
(Not Shown)
04730-207-15-00
85
Lid, Drain Quench
05700-002-67-16
Thermostat
05930-003-13-65
Solenoid Valve
04810-100-09-18
To Cold Water Supply
Box, Drain Quench
05700-002-69-96