Table of Contents
Advertisement
For example: Press
to select 25 mm (1 inch) and the
machine will not trim a jump stitch of 25 mm or less
before moving to the next stitching.
Note
• If design has many trims it is recommended to
select a higher jump stitch trim setting in order to
reduce the amount of excess tails on backside of
fabric.
• The higher number of the jump stitch length
selected, the fewer number of times the machine
will trim. In this case, more jump stitches remain on
the surface of the fabric.
Adjusting the Embroidery Speed
a
Press
.
The settings screen appears.
b
Press
.
The embroidery settings screen appears.
c
Display [Max Embroidery Speed] in the embroidery
settings screen.
d
Use
to change the maximum embroidery
speed.
Memo
• SPM is the number of stitches embroidered in one
minute.
• Decrease the embroidery speed when
embroidering on thin, thick, or heavy fabrics and
when using a speciality thread like a metallic
thread.
• The setting specified before the main power is set
to OFF remains selected the next time that the
machine is turned ON.
MAKING EMBROIDERY ADJUSTMENTS
Changing the Thread Color Display
You can display the name of the thread colors or
embroidery thread number.
Memo
• Colors on the screen may vary slightly from actual
spool colors.
• [Original], imported data remains the brand thread
created with the software, is set as a default.
a
Press
.
The settings screen appears.
b
Press
.
The embroidery settings screen appears.
c
Display [Thread Color] in the embroidery settings
screen.
d
Use
to display the name of the thread colors
or the embroidery thread number.
e
Use
to select a thread brand.
Aligning the Pattern and the Needle
Example: Aligning the lower left side of a pattern and
the needle
3
77
Advertisement
Table of Contents
