Adjusting The Screen; Touch Panel Is Malfunctioning - Brother BP3600 Operation Manual

ADJUSTING THE SCREEN

c
Raise the presser foot lever.
d
Remove the connector of the embroidery foot "W+"
with LED pointer from the connector on the back of
the machine.
e
Use the included disc-shaped screwdriver to loosen the
screw for the embroidery foot, and then remove the
embroidery foot "W+" with LED pointer.
f
Position the embroidery foot "W+" with LED pointer
on the presser foot bar by aligning the notch of the
presser foot to the large screw.
Side view
g
Hold the embroidery foot in place with your right
hand, and then use the disc-shaped screwdriver to
securely tighten the screw for the embroidery foot.
1 Screw for embroidery foot
CAUTION
• Use the disc-shaped screwdriver to firmly
tighten the screw for the embroidery foot. If
the screw is loose, the needle may strike the
embroidery foot and possibly cause injury.
108
a
a
h
Plug the connector of the embroidery foot "W+" with
LED pointer into the jack on the back left side of your
machine.
i
Press to unlock all keys and buttons.
 All keys and operation buttons are unlocked, and the
previous screen is displayed.
ADJUSTING THE SCREEN

Touch Panel is Malfunctioning

If the screen does not respond correctly when you
touch a key (the machine does not perform the
operation or performs a different operation), follow the
steps below to make the proper adjustments.
a
Holding your finger on the screen, turn the main
power switch to OFF and back to ON.
 The touch panel adjustment screen appears.