Table of Contents
Advertisement
Cleaning the blender
W Risk of injury from sharp blades!
Do not touch blender blades with bare
hands. Clean them with a brush.
Warning!
Do not wash blender holder in the dish-
washer or leave it in water.
■ Clean blender holder under running
water.
■ Lid, funnel and blender jug can be
washed in the dishwasher.
Note:
Lid can be disassembled for cleaning.
Figure H:
■ Pull funnel upwards out of the lid.
■ Press insert downwards out of the lid.
Tip: After processing liquids, it is often suffi-
cient to clean the blender without removing
it from the appliance. Pour a little water and
washing-up liquid into the attached blender.
Switch on the blender for several seconds
(setting M). Pour out the water and rinse out
the blender with clear water.
Troubleshooting
W Risk of injury!
Before eliminating a fault, pull out the mains
plug.
The multi-function arm must be engaged
in each operating position.
Initially try to eliminate the problem which
has occurred with the help of the following
information.
Fault
Appliance does not start.
Remedial action
■ Check the power supply.
■ Check the mains plug.
■ Check multi-function arm.
Correct position? Engaged?
■ Screw on bowl all the way.
■ Attach drive cover to unused drives.
■ The safety lock is active.
Switch appliance to 0/off and then back
to the required setting.
Fault
Appliance switches off during use. The
overload protection feature has been
activated. Too much food was processed at
one time.
Remedial action
■ Switch off the appliance and pull out the
mains plug.
■ Leave the appliance to cool down for
15 minutes in order to deactivate the
overload protection.
■ Reduce processing quantity. Do not
exceed permitted maximum quantities
(see "Application examples").
■ Switch on appliance again. If the motor
still does not start, leave the appliance
to cool down for a longer period (at least
1 hour).
Fault
While the drive was running, the release
button was inadvertently pressed. The
multi-function arm moves up. The drive
switches off, but does not stop in the tool
change position.
Remedial action
■ Set the rotary switch to 0/off.
■ Move multi-function arm to
position 2.
■ Switch on appliance (setting 1).
■ Switch off appliance again.
Tool stops in tool change position
Fault
Blender does not start working or stops
during use, the drive is "humming". Blade is
blocked.
Remedial action
■ Switch off the appliance and pull out the
mains plug.
■ Detach the blender and remove the
obstruction.
■ Re-attach the blender.
■ Switch on the appliance.
Important information
If the fault cannot be eliminated, please
contact customer service.
Troubleshooting
en
21
Advertisement
Chapters
Table of Contents
