Operation; Bowl And Tools - Bosch MUMX25TLCN Instruction Manual

en

Operation

Operation
W Risk of injury!
Do not insert mains plug until all prepa-
rations for working with the appliance are
complete.
Warning!
Do not operate the appliance without an
accessory / tool in the operating position.
Do not operate the appliance empty. Do not
expose appliance or accessories to heat
sources. Parts are not microwave-safe.
■ Before operating the appliance
and accessories for the first time,
clean thoroughly; see "Cleaning and
servicing".
Preparation
■ Place the base unit on a smooth, clean
surface.
■ Prepare cable (Fig. C).
a) Appliances with cord store:
Pull out cable to the required length.
b) Appliances with automatic cord
winder:
Pull out the cord in one go to the
required length (max. 100 cm) and
slowly release; the cord is locked.
Reducing the cord length:
Pull gently on the cord and allow it to roll
up to the required length. Then gently
pull the cord again and slowly release;
the cable is locked.
Warning!
Do not twist the cord when inserting it. If
the appliance features an automatic cord
winder, do not insert the cord manually. If
the cord jams, pull out the cord all the way
and then allow it to wind up.

Bowl and tools

W Risk of injury from rotating tools
While the appliance is operating, never
place fingers in the mixing bowl. Attach the
cover (12) before operating the appliance!
Keep hands clear of rotating parts. Do
not change tools until the drive has come
to a standstill – when the appliance is
18
switched off, the drive continues running
briefly and stops in the tool change position.
Do not move multifunction arm until the tool
is at a standstill.
For safety reasons the appliance cannot be
operated in position 2-4 until the bowl has
been inserted and turned all the way or the
tool drive cover (7) has been attached.
Warning!
Use bowl with this appliance only. Insert
tools firmly into the drive until they lock into
position.
"Absolute" stirrer (14)
for stirring dough, e.g. sponge
mixture or mousse, and for folding
in beaten egg whites or cream.
Solid metal whisk (15)
for whisking egg whites, cream and
light dough, e.g. sponge mixture.
Kneading hook
„High performance" with
dough deflector (16)
for kneading heavy dough and for
folding in ingredients which are not to be cut
(e.g. raisins, chocolate chips).
Important information
concerning the use of the whisk
Figure D:
The whisk should just touch the bottom
of the bowl in order to mix the ingredients
thoroughly. The whisk can be positioned
higher for large quantities.
Adjust the height of the whisk as follows:
■ Remove mains plug.
■ Press the Release button and
move multi-function arm to
position 1.
■ Insert the whisk into the drive until the
whisk locks into position.
■ Hold whisk in place and loosen nut
clockwise using enclosed key (on the
base of the appliance).
■ Set the whisk to the optimum height by
rotating the whisk:
– Turn clockwise: Raise
– Turn anti-clockwise: Lower