Clevo W243HUQ Series Service Manual page 38

Disassembly
Processor Installation Procedure
Figure 10
Processor 1. Insert the CPU
Installation
IT!), and turn the release latch
2. Remove the sticker
3. Insert the heat sink
a. Insert the CPU.
b. Turn the release latch to-
4. Tighten the CPU heat sink screws in the order
wards the lock symbol.
5. Replace the component bay cover (don't forget to replace the fan cable) and tighten the screws
c. Remove the sticker from
the heat sink and insert
the heat sink.
d. Tighten the screws.

A. CPU
D. Heat Sink
• 3 S crews
2 - 14 Removing and Installing a Processor
(Figure 10a), pay careful attention to the pin alignment, it will fit only one way (DO NOT FORCE
A
towards the lock symbol
B
(Figure 10c) from the heat sink.
C
as indicated in
D
a.
A
b.
B
(Figure 10b).
Figure 10d.
, &
(the order as indicated on the label and
1 2 3
c.
d.
D
3
1
2
Figure 10d).
(page 2 - 9).
C
Note:
Tighten th e scre ws
in the order as indi-
cated on the label.