Features; Specifications; Installation And Operating Instructions - Macurco TX-6-AM User Instructions

Features


ETL Listed to UL 61010-1

Low level meter capable of displaying from 0-100 ppm Ammonia

The TX-6-AM meets NIOSH and OSHA standards for gas exposure
 Selectable fan and alarm relay activation
 5 A SPDT fan relay controls starters of exhaust fans

0.5 A N.O. or N.C. alarm relay connects to warning devices or control panels

4-20 mA Current Loop

TX-6-AM mounts on a standard 4x4 electrical box and becomes cover for the box
 Supervised system: any internal detector problem will cause the fan & alarm relay to activate
 Calibration kit is available. One screw allows access for calibration or gas test

Specifications


Power: 3 W (max) from 12 to 24 VAC or 12 to 32 VDC

Current @ 24 VDC: 75 mA in alarm (two relays), 50 mA (fan relay only) and 23 mA stand by
 Shipping Weight: 1 pound (0.45 kg)
 Size: 4 1/2 x 4 x 2 1/8 in. (11.4 X 10.2 X 5.4 cm)

Color: Dark gray

Connections: plugs/terminals

Mounting box: (not included) 4x4 electric
 Fan relay: 5 A, 240 VAC, pilot duty, SPDT, latching or non-latching
 Fan relay actuation: selectable at diS (disable), 15, 20, 25 (default), 30, 35, 40, 45, 50, 55, 60, 65, 70, or 75 ppm NH3

Fan Delay Settings of 0, 1, 3 (default), 5 and 10 minutes

Fan Minimum Run Time settings are 0 (default), 3, 5, 10 or 15 minutes

Fan relay latching or not latching (default) selectable
 Alarm relay: 0.5A 120 V, 60 VA
 Alarm relay actuation: selectable N.O. (default) or N.C.

Alarm relay settings: diS, 20, 25, 30, 35, 40, 45, 50, 55, 60, 65, 70, 75 (default), 80, 85, 90, 95 or 100 ppm NH3

Current Loop: 4-20 mA for 0-100ppm NH3

Buzzer: 85 dBA at 10cm settable to off (default) or on
 Digital display: 3 digit LED selectable to off (default) or on.
 Operating environ: 0°F to 125°F (-18C to 52C).10 to 90% RH

INSTALLATION AND OPERATING INSTRUCTIONS

The following instructions are intended to serve as a guideline for the use of the Macurco TX-6-AM Ammonia Detector. It is not to be
considered all-inclusive, nor is it intended to replace the policy and procedures for each facility. If you have any doubts about the
applicability of the equipment to your situation, consult an industrial hygienist or call Technical Service at 1-877-367-7891.
selectable to off or on (default)
,
5