o Apply the sealing strip provided around the edge of the
appliance.
o The protective covering must be removed from both sides.
o Do not leave a gap in the sealing agent or overlap the thickness.
o IMPORTANT: Do not use a silicon sealant to seal the appliance
against the aperture. This will make it difficult to remove the hob
from the aperture in future, particularly if it needs to be
serviced.
o Carefully turn the hob back over and then gently lower it into the
aperture hole that you have cut out.
o There are holes on the base or the sides of the hob that you can
fix the four brackets to. There are three holes in each one of the
brackets.
o You should place the
bracket on the underneath
of the hob, in a position
that is appropriate for the
aperture that you have cut
out. Using the screws
provided, fix the bracket
to the hob. These screws
MUST be securely
tightened.
22