*1 Use a CVVS or CPEVS cable (Max. total length of 200 m) if there is a source of electrical interference near by (e.g., factory) or the total length of control wiring
exceeds 120 m.
2 Cable Connections
<1> Schematic Diagram of a Unit and Terminal Block Arrangement
To remove the front panel of the control box, unscrew the four screws and pull the panel forward and then down.
Power supply terminal block
* When connecting the cables, first temporarily fasten the cables, and then fasten them properly after the cables have been
connected to the terminal blocks within the control box.
<2> Precautions when fastening screws
* Faulty contacts due to loose screws may cause overheating and fire.
* Using the circuit board while it is damaged may cause overheating and fire.
1 Screw fastening torque
Power supply terminal block (TB2)...M8 screw: 10 to 13.5 N·m
Use the following methods to check that the screws have been fastened.