Table of Contents
Advertisement
Installation Manual
Unpacking the ATM
► Unpack the machine on top of the palette.
1. Cut the straps that are fastened around the box with a knife.
2. Use an appropriate tool to remove the nails from the palette. (Refer to figure below)
3. Remove the lid, then box from the top. Do not discard the packaging materials until you have
4. Verify the contents carefully with the packing list to be sure all items listed are included.
Notify your distributor of any shortages.
5. If only the palette needs to be removed, lift the whole machine from the bottom and set it
► Removing equipment from the Palette
1. Removing bolts from equipment locking bracket.
2. Removing the Adjustor with a spanner.
3. Lifting equipment using a lifting device.
4. Moving this ATM machine to the installation site.
PRECAUTION:
MX8800 ATM machine is very heavy equipment and can cause injuries if not handled with
caution. Read the following carefully.
▪ Firmly close the vault door and lock the door by turning the knob completely.
▪ Only experienced staff members should move the heavy machine.
▪ Do not tilt the ATM when moving.
(Be careful when cutting the straps. Refer to figure below.)
verified any shipping damage claim. Contact your distributor immediately if you see any
shipping damage. Store the box in a safe place to re-use or discard of appropriately.
aside.
© Hyosung TNS Inc. All Rights Reserved.
Chapter2. Installation Information
2-2
Advertisement
Table of Contents
