Installer Setting - Installer Setting Code Table - LG UM60F Instruction Manual

Installer Setting - Installer Setting Code Table

Installer Setting Code Table
No. Function
0 Mode override
Ceiling height
1
Selection
Group control
2
Auxiliary heater
Mode Override
This Function is only for Non-Auto Changeover H/P model.
Ceiling Height Selection
Indoor unit connected to wired remote controller operate as wired remote controller setting.
Group Control (optional)
This function is only for group control. Please don't set this function in case of non-group
control.
After setting group control of the product, turn off the power then turn it back on after 1
minute.
Auxiliary heater
This function is only applied to models with Auxiliary Heater function being activated.
Function code
0 : Set to master
0
1 : Set to slave
1 : Standard
2 : Low
1
3 : High
4 : Super high
0 : Set to master
2
1 : Set to slave
2 : Check master/slave
3 : Set to auxiliary heater
2
4 : Cancel auxiliary heater
5 : Check auxiliary heater Installation
INSTALLATION INSTRUCTIONS
Setting value
63
Remote controller LCD
00
01
11
12
13
14
20
21
22
23
24
25