Lifting Loads - ABB HT571908 Operation Manual

2.10
2.10
WARNING
© Copyright 2016 ABB. All rights reserved.
Safety

Lifting loads

Lifting loads
Suspended loads
Loads not suspended in compliance with regulations may lead to per-
sonal injury or accidents with fatal consequences.
Loads must always be fastened to technically perfect lifting gear with
τ
sufficient loading capacity.
Make sure the load is suspended properly on the crane hook.
τ
Do not let anyone stand beneath a suspended load.
τ
Wear safety gloves to protect against mechanical hazards.
Wear safety helmet.
In the case of two or more suspension points, the slinging angle must not
exceed 45°. This avoids excessive loading due to inclined tensile loading.
Fasten turbocharger assemblies / components as described in respec-
τ
tive handling steps.
Before attaching slings, allow turbocharger components to cool down
τ
(maximum 80°C).
Use suitable protection at sharp edges.
τ
Completely screw in assembly / fitting devices without fail so that they
τ
cannot work loose during use.
Use assembly / fitting devices only for applications described.
τ
Make sure removed turbocharger components stand safely and se-
τ
curely.
Operation Manual / TPS44-F.. - TPS61-F..
2
2.10 Page 33