Lifting Of Loads; Fig. 9: Attachment Of Loads On The Crane Hook; Fig. 10: Attachment Angle - ABB PT003924 Operation Manual

Operation Manual / Power2 340-H / Low-pressure stage
2 Safety / 2.10 Lifting of loads
2.10

Lifting of loads

WARNING
Suspended loads
Loads that are not attached according to regulations can cause injury to
personnel or fatal accidents.
Loads must always be fastened to properly functional lifting gear with a
u
sufficient load limit.
Pay attention to the correct attachment of loads on the crane hook.
u
People must not stand beneath suspended loads.
u
Wear safety gloves to protect against mechanical hazards.
Wear safety helmet.
Fig. 9: Attachment of loads on the crane hook
Fig. 10: Attachment angle
If there are two or more suspension points, the attachment angle of 45° must not be ex-
ceeded. This prevents excessive loading due to diagonal pull.
Before looping around the components of the low-pressure and high-pressure stage, al-
u
low them to cool down (maximum 80 °C).
Attach components of the low-pressure and high-pressure stage as described in the re-
u
spective action steps.
Use a suitable edge guard if there are sharp edges.
u
The assembly devices must be completely screwed in and must not unscrew during use.
u
Use assembly devices only for the described applications.
u
Put down dismantled components of the low-pressure and high-pressure stage in such a
u
way that they cannot tip over.
© Copyright 2022 ABB. All rights reserved. HZTL4053_EN Rev.F March 2022