NETGEAR RBK20 User Manual page 144

To sync the router and the satellite:
1. Place the satellite in the same room as the Orbi router.
Use this satellite location only during the sync process.
2. Connect the satellite to a power source.
3. If the Power LED on the back of the satellite does not light, press the Power On/Off
button.
4. Wait for the satellite's ring LED to light solid white or magenta.
5. Press the Sync button on the router and then within two minutes, press the Sync
button on the satellite.
The satellite's ring LED pulses white, then lights one of the following colors for about
three minutes and then turns off:
• Blue. The Orbi router and satellite successfully synced, and the connection
between the router and satellite is good.
• Amber. The Orbi router and satellite successfully synced, and the connection
between the router and satellite is fair. Consider moving the Orbi satellite closer
to the Orbi router.
6. Move the satellite to a location closer to the middle of your home.
7. Connect the satellite to a power source.
8. If the Power LED on the back of the satellite does not light, press the Power On/Off
button.
The satellite's ring LED pulses white, then lights one of the following colors for about
three minutes and then turns off:
• Blue. The Orbi router and satellite successfully synced, and the connection
between the router and satellite is good.
• Amber. The Orbi router and satellite successfully synced, and the connection
between the router and satellite is fair. Consider moving the Orbi satellite closer
to the Orbi router.
• Magenta. The Orbi router and satellite failed to sync. Move the satellite closer
to the router and try again.
Troubleshooting
Orbi WiFi System
141 User Manual