Advertisement
Getting Started
Thank you for buying the Presto Soft Box from Ikan. Please carefully read the instructions and guide before operating the products. The guide includes
product usage and maintenance. When you operate the product, please make sure that you have read the instructions carefully. All the content of the
manual is based on up-to-date information; technical data subject to change without notice.
Step-by-Step Guide to preparing and installing your Presto Soft Box
Step 1: Remove the Presto soft box from the
carrying pouch. (Note: be careful that the box
doesn't spring open when removing it from
carrying pouch.)
Step 4: Check the inside of the soft box to make
sure that all of the material is fully expanded
and there are no cuts or openings.
www.ikancorp.com | 1.713.272.8822 | sales@ikancorp.com
Step 2: Gently allow the frame of the soft box
to open and take shape. This allows the box to
take shape and start forming the frame.
Step 5: Placing the soft box on the light and
fitting it into place. The soft box will slip over
the barn doors and slid around the edges of the
light. The back flaps will fit around the light and
the hook straps will attach to the loop patches
on the side flaps.
Step 7: (Optional) The included egg crate can
be placed on the soft box to allow the soft light
to be more controlled with less light spill.
Step 3: Straighten the rods at each corner of
the box. Allow the magnets to attach and form a
solid rod locking the box in open position.
Step 6: Once the back flaps have been set take
the two long elastic straps and attach them over
the back of the light. (Note: Pushing the barn
doors out from the front of the box through the
diffusion will allow the box to stay on better.)
because we're filmmakers too
Advertisement
