Remote Control; General - Insignia NS-24D310MX17 User Manual

Problem Solution
No output
• Adjust the audio balance. See
from one of
Adjusting sound settings
the speakers.
page 44.
• Test the TV's speakers. See
the TV speakers
or both of the speakers fails, try one
of the following solutions:
• Make sure that the audio cables
• Make sure that the audio cables
• Try a different set of audio cables.
• Make sure that the sound on the
• Try connecting the device to a
After images
• Do not display a still image, such as
appear.
a logo, game, or computer image,
for an extended period of time. This
can cause a permanent after-image
to be burned into the screen. This
type of damage is not covered by
your warranty.

Remote control

Problem Solution
Remote
• Make sure that the power cord is
control does
plugged into a working outlet.
not work.
• Make sure that there are no
obstructions between the remote
control and the remote control
sensor on the front of the TV.
• Point the remote control directly at
the remote control sensor on your
TV. For the location of the remote
control sensor, see
remote control
• The supplied batteries are wrapped
tightly in clear plastic. Make sure
that you have removed this plastic
from the batteries.
• Make sure that the batteries are
installed correctly. See
remote control batteries
page 29.
• Replace dead batteries with new
batteries. See
control batteries
on
Testing
on page 63. If one
are connected correctly and
securely to your TV.
are connected to the AUDIO OUT
jacks on the connected device.
connected device is not muted.
different TV. If you do not hear
sound, the problem is with the
device.
Aiming the
on page 29.
Installing
on
Installing remote
on page 29.
www.insigniaproducts.com
Problem Solution
Trouble
• See instructions and a table of
programming
common codes in
your existing
universal remote controls
universal
page 30.
remote
• Codes are subject to change. For
control.
up-to-date codes, go to
universal remote control codes
page 30, or visit
www.insigniaproducts.com/remotecodes
• Replace dead batteries with new
batteries.
• Refer to the User Guide that
accompanied your universal remote
control and contact the
manufacturer if problems persist.

General

Problem Solution
No power.
• Make sure that the power cord is
plugged into a working outlet.
• Unplug the power cord, wait 60
seconds, then plug the cord back in
and turn on your TV.
• Other devices (for example, a
surround sound receiver, external
speakers, fans, or hair dryers) may
be interfering with your TV. Try
turning off one device at a time to
determine which device is causing
interference. After you have
determined which device is causing
interference, move it further from
the TV to eliminate the interference.
"No signal"
• Press INPUT and make sure that you
error message
have selected the correct input for
is displayed.
the device or service you are trying
to use.
• If you are using a cable or satellite
box, use the remote that came with
that box to change channels.
After Auto
• Reception can vary by channel
Channel
depending on the broadcast power
Search, there
level of a given station. Contact your
are no
cable or satellite TV provider.
channels.
• Make sure that the antenna or
cable/satellite TV is connected
securely to your TV.
• Try replacing the cable between the
antenna/cable or cable/satellite box
and your TV.
When I press
• Turn on the device. Your TV
INPUT, I
automatically detects and displays
cannot select
which video jacks have devices
my device (it is
connected to them when the
grayed out).
devices are turned on.
• Turn off Auto Input Sensing. See
Turning Input Sensor on or off
page 59.
24" 720p 60Hz LED TV
Programming
on
Viewing
on
on
67