BandLuxe R500 Series User Manual page 29

WiFi Setup
encryption requires 10 hexadecimal digits (letters a-f and numbers 0-9
are valid). The 128-bits encryption requires 26 hexadecimal digits (letters
a-f and numbers 0-9 are valid).You can set up to four different keys.
802.1x
IEEE 802.1x is an authentication system for devices connecting to a WiFi
network. This system requires the use of an authentication server that is
part of the network.
Encryption: Only WEP is available.
Rekey Interval: Enter a key renewal value to tell the Router how often it
should change the encryption keys. The value must be between 60-
99999.
RADIUS stands for Remote Authentication Dial-In User Service. It is a
networking protocol that uses access servers to provide centralized
management of access to large networks.
RADIUS Server: Enter the IP Address of the RADIUS server.
RADIUS Port: Enter the port number of the RADIUS server. The default
value is 1812.
RADIUS Key: Enter the key shared between the Router and the server.
Shared Key
An authentication system that uses a simple challenge/response protocol
with a WEP key.
Encryption: Only WEP is available.
WPA
WPA, or WiFi Protected Access, is a WiFi standard that was designed to
improve the security features of WEP. WPA uses two encryption methods,
TKIP and AES, with dynamic keys. This option features WPA used in
coordination with a RADIUS server. (This should only be used when a
RADIUS server is connected to the Router.)
Encryption: Choose TKIP, AES, TKIPAES from the drop down list. AES
is a stronger encryption method than TKIP. TKIPAES uses either TKIP or
AES during the connection.
Rekey Interval: Enter a key renewal value to tell the Router how often it
should change the encryption keys. The value must be between 60-
27