Burner Component Installation - Dacor Epicure EG366SCH Installation Instructions Manual

Burner Component Installation

WARNING
• Never attempt to operate the cooktop with any of the
burner parts removed.
• Do not attempt to adjust the burner air mixture set-
tings. All adjustments are preset at the factory.
• Remove the burner parts and grates from their shipping
packages.
• Install the burners as shown. When installing the burn-
er components, twist each piece back and forth slightly
until it drops completely into place. The burners will
not operate properly unless all of the burner pieces are
properly seated.
• Gently set the grates on top of the spill trays. Make
sure that the rubber feet are positioned in the dimples.
On model EG366, the center grate is larger than the
other two.
Ridge on bottom
of burner cap
STEP 3: Install
burner cap.
Ridge on cap
must surround
top of ring.
STEP 2: Install
burner ring. Line
up ring tabs
with head slots.
Twist back and
forth to assure
proper seating.
STEP 1: Install
burner head.
Put locating
tap into keyed
hole.
Keyed hole
Crown Burner Assembly
10
Installation Instructions
Burner cap
Burner ring
Burner head
Burner base
Crown
burner
Ridge on bottom
of burner cap
STEP 3: Install
burner cap. Ridge
on cap must sur-
round top of ring.
STEP 2: Turn
ring until it drops
into place. Twist
back and forth
to assure proper
seating.
STEP 1: Put
burner ring on
top of the head.
Stack Burner Assembly
Spill tray
Stack
burner
Burner cap
Burner ring
Burner base