Table of Contents
Advertisement
Gas Line Connection
WARNING
•
Verify that the gas supply meets specifications before
connection. See page 3.
•
The maximum gas supply pressure to the regulator
must never exceed ½ pounds per square inch (psi) or
3.5 kPa.
•
Do not install or use the cooktop without the included
gas regulator installed.
•
Ensure that the arrow on the regulator points in the
direction of the gas flow, towards the cooktop.
•
Do not apply excessive pressure when tightening gas
connections and fittings.
•
Do not use Teflon tape or plumber's putty on flexible
gas line connections.
•
Test the gas lines for leaks as instructed before use.
Do not use a flame to check for leaks.
•
The gas supply pressure for testing the regulator set-
ting shall be at least 1 inch water column (249Pa)
above the specified manifold pressure. See page 3.
•
The cooktop and shut-off valve must be disconnected
from the gas supply piping system during any pres-
sure testing exceeding ½ psi (3.5 kPa).
•
The cooktop must be isolated from the gas supply pip-
ing system by closing the shut-off valve to the cooktop
during any gas supply piping system pressure testing
equal to or less than ½ psi (3.5 kPa).
•
For LP gas installations, the LP gas tank must have
its own high-pressure regulator in addition to the pres-
sure regulator supplied with the cooktop.
IMPORTANT
Within the Commonwealth of Massachusetts, this
appliance must be installed by a licensed plumber or gas
fitter.
1.
Attach the gas pressure regulator (included with the
cooktop) to the gas inlet on the cooktop. The inlet is
located on the bottom, at the right rear portion of the
chassis. For tight installations, the regulator may be
installed upstream from the pipe nipple, anywhere
between the shut-off valve and the cooktop. For best
performance, minimize gas pressure loss by attaching
the regulator as close as possible to the cooktop gas
inlet.
2.
Complete connection of the gas supply to the cooktop
by installing a minimum ½" flexible gas line (not includ-
ed) between the pressure regulator and the shut-off
valve.
Installation Instructions
3.
Check for gas leaks:
◊
Turn all cooktop control valves to the
◊
Turn on the gas supply valve and check all lines
and connections for leaks using a soap and water
solution or a gas leak detector.
◊
Turn the gas supply valve off.
Burner Component Installation
WARNING
•
Never attempt to operate the cooktop with any of the
burner parts removed.
•
Do not attempt to adjust the burner air mixture set-
tings. All adjustments are preset at the factory.
•
Remove the burner parts and grates from their shipping
packages.
•
Install the burners as shown. When installing the burn-
er rings, insert the five (5) tabs on the bottom of each
ring into the tabs on the top of each burner base. Twist
each piece back and forth slightly until it drops com-
pletely into place. The burners will not operate properly
unless all of the burner pieces are properly seated.
•
Gently set the grates on top of the spill trays. Make
sure that the rubber feet are positioned in the dimples.
On model ESG366, the center grate is larger than the
other two.
OFF position.
Grate
Burner cap
Burner ring
Top frame
Burner base
(fixed)
9
Hide quick links:
Advertisement
Table of Contents
