Lithium Battery Connection Diagram - Ultra Power UP200 Duo Instruction Manual

LITHIUM BATTERY CONNECTION DIAGRAM

UP200 Duo charger comes with the built in switch mode power supplies.
You can connect the AC power cord directly to the main AC socket
(100-240V AC), or you can connect an external power supply (11-18v)
or 12v car battery to the DC input socket.
PLEASE NOTE: The charger MUST be powered before you connect a
battery to the charger, failure to have the charger powered up before
connecting a battery can cause charger failure if any connections are
incorrect. The charger must to be powered in order for it to recognize
an incorrect connection and warn you of this before you can go too far
and cause damage. If you get the warning "Reverse Polarity" you
MUST disconnect the battery immediately! Never remove power from
the charger first.
Before connecting any battery it is absolutely essential to check one
last time that you have set the charging parameters correctly. If the
settings are incorrect, the battery may be damaged, and could even
burst into flames or explode. Check that your wiring is correct polarity
from the charger to your battery, double check to be safe.
To avoid short circuiting a battery you must always connect the charge
leads to the charger first, and only then to the battery. Always unplug
the battery from the charge leads when disconnecting the pack, never
remove the leads from the charger when a battery is connected to
them.
BALANCE SOCKET:
The balance wire attached to the battery must be connected to the
charger with the black wire aligned with the negative marking. Take
care to maintain correct polarity! (See the wiring diagram on the next
page.)
CONNECTING THE BATTERY
To connect a lithium battery with a balance plug please follow these
procedures.
10