Power Switch Setting - Hoover DM71DM03001 User Manual

PrEParing TO USE YOUr CLEanEr
Affix carrying handle to
Insert handle into body
the back of product
of cleaner. Slide into
position.
Ensure handle is flush
with body of cleaner.
Tighten large screw (pre-
fitted to handle upper
hole). Insert small screw
into handle lower hole
and tighten.
Connect hose to back of
product.

POWEr SWiTCH SETTing

Switching on and off
Push bottom of the On/Off switch to switch on.
Push top of the On/Off switch to switch off.
CLEanEr LOCK rELEaSE
Unlock the cleaner by pressing down on pedal
with foot. For floor cleaning under low
furniture and some maintenance tasks
simply press the pedal again and
lower handle to the floor.
CarPET CarE COnTrOL SELECTOr
Screw top two provided
screws to affix carrying
handle in place
latch hose retainer
to hose support.
- 4 - - 4 -
The carpet care control selector raises and lowers the height of
the nozzle.
Ensure that the cleaner is in the upright
(parked) position and move the selector
to the required setting for the carpet
type or floor covering.
1 2 3 4
To obtain the best performance and
energy efficiency
that the adjustment setting position 1 is
used for the main cleaning operations.
The other adjustment settings are for
ease of use, use on longer pile carpets,
or for specialist cleaning tasks.
Settings
1. Best performance and energy efficiency, short to medium pile
carpets, hard wooden floors, wooden floor boards with crevices,
ceramic tiles.
2. Medium pile carpets, delicate floor coverings such as vinyl or
linoleum, parquet flooring.
3. For longer pile carpets the motion resistance may increase.
Use these intermediate settings to reduce the force required to
push the vacuum cleaner.
4. luxury carpet and Tool mode
imPOrTanT: Using this cleaner for loop pile carpets with
pile greater than 30mm is not recommended. Please consult
the floorcare/carpet manufacturer's recommended cleaning
instruction before vacuuming.
imPOrTanT: When cleaning delicate hard floors such as vinyl or
linoleum the selector switch must be moved to position 2. Failure
to do so may cause damage to the floor surface.
This vacuum cleaner is supplied with an Energy Label as required
by European regulation (EU) 665/2013. If the label shows a red
prohibition circle on the right covering the hard floor symbol, then
this indicates that the vacuum cleaner is not suitable for use on
hard floors.
#1
nOTE: Dust pick up ability carpet, dust pick up ability hard floor,
and energy efficiency in accord with Commission Regulations
(EU) 665/2013 and (EU) 666/2013.
gB
#1
it is recommended