Table of Contents
Advertisement
User Checklist
If your cleaner is not working properly run through the following checklist.
1. Is there a working electricity supply to the cleaner?
Check with another electrical product.
2. Is the dust container full or choked with fine dust?
To empty the dust container, see the instructions on page 5.
3. Is the hose blocked?
To clear a blockage, see the instructions on page 7.
4. Is there a blockage in the cleaner base?
To clear a blockage, see the instructions on page 7.
5. Are the filters blocked?
To clear the filters, see the instructions on page 6.
6. Is the nozzle height set correctly?
To set the carpet care control selector, see the instructions on page 4.
7. Are the brushes rotating correctly?
To check the brushes, see the instructions on page 7.
8. Has the cleaner overheated?
If so, it will take about 30 minutes to reset itself.
If there is any doubt call the Hoover service Office for advice. They may be able
to assist you over the telephone. A service charge will be made if the cleaner is
examined and found to be in working order, has not been assembled in accordance
with these instructions or has been used incorrectly. working order, has not been
assembled in accordance with these instructions or has been used incorrectly.
Warning!
A thermal cut out switches off the cleaner to prevent overheating if it is used
when full or there is a blockage or dirty filters. If this should happen switch off,
unplug and correct the fault.
It will take about 45 minutes for the cut out to automatically reset.
imPOrTanT:
Do not run cleaner over the supply cord as this could damage
the supply cord insulation.
important information
Hoover Service
should you require service at any time, please contact your local Hoover
service Office.
Hoover spares and Consumables
Always replace parts with genuine Hoover spares. These are available from
your local Hoover dealer or direct from Hoover. When ordering parts always
quote your model number.
USE OnLY HOOVEr SParES
COnSUmaBLES & SParE ParTS
PRE-MOTOR FILTER & sPOnGE KIT
PrE-mOTOr FIlTEr
HOSE
AGITATOR
mInI TUrbO nOzzlE
PArQUET CArESSE nOzzlE
bElT
Hoover's factories have been independently assessed for quality. Our products
are made using a quality system which meets the requirements of IsO 9001
gUaranTEE STaTEmEnT
The guarantee conditions for this appliance are as defined by our representa-
tive in the country in which it is sold. Details regarding these conditions can be
obtained from the dealer from whom the appliance was purchased. The bill of
sale or receipt must be produced when making any claim under the terms of
this guarantee.
Subject to change without notice.
- 8 -
- 8 -
CODE
U44 - 35600746
S77 - 03875160
D1 - 04345084
y202E - 35601613
J21 - 04845086
G101PC - 35600887
v17 - 0916198
Quality
gB
Advertisement
Table of Contents
