GETTING TO KNOW YOUR CLEANER COrD sTORAGE Effortless cleaning with SWIvEl HOOK HAnDlE your new Hoover POWEr COrD DUsTInG brUSH ClEAnEr bODy GROOMInG nOzzlE On/Off SWITCH CARRyInG HAnDlE DOOr rElEASE FlExIblE HOSE HOSE rETAInEr HOSE SUPPOrTS DUST ExTEnSIOn TUbE* COnTAInEr...
CarPET CarE COnTrOL SELECTOr PrEParing TO USE YOUr CLEanEr The carpet care control selector raises and lowers the height of the nozzle. Ensure that the cleaner is in the upright (parked) position and move the selector to the required setting for the carpet type or floor covering.
AlWAyS work with the cleaner below you. Ensure it is imPOrTanT: For optimum cleaning performance, always keep positioned up against the bottom step. your filters clean. Hoover recommends to wash Dust Manager cassette filters after 5 container empties. DO nOT attach hose retainer when cleaning the stairs.
CLEaning THE FiLTErS* Washing pre-motor and exhaust filter: Washing filter and foam: The pre-motor filter should be washed every Rotate the BLUE filter pack to the unlock three months. position to release it from the dust container. The Carbon filter is normally maintenance free, this component should not be washed.
CLEaring a BLOCKagE CHanging BELT Or BrUSHES Refit brush assembly • Hold the brush assembly imPOrTanT: Switch the cleaner imPOrTanT: Switch cleaner off and and stretch the belt until remove plug from electricity supply off and remove the plug from the brush mountings slot before checking the brushes or remov- electricity supply before dismantling...
Page 8
If so, it will take about 30 minutes to reset itself. PArQUET CArESSE nOzzlE G101PC - 35600887 If there is any doubt call the Hoover service Office for advice. They may be able bElT v17 - 0916198 to assist you over the telephone. A service charge will be made if the cleaner is examined and found to be in working order, has not been assembled in accordance with these instructions or has been used incorrectly.