Safety Precautions - Daikin ARYN20LV1 Instruction Manual

Wall mounted split-type air conditioner
Hide thumbs Also See for ARYN20LV1:
Table of Contents

Advertisement

Available languages

Available languages

Интернет-магазин «Мистер Климат»
INSTALLATION MANUAL
This manual provides the procedures of installation to ensure a safe and good standard of operation for the air
conditioner unit.
Special adjustment may be necessary to suit local requirement.
Before using your air conditioner, please read this instruction manual carefully and keep it for future reference.
This appliance is intended to be used by expert or trained users in shops, in light industry and on farms, or for
commercial use by lay persons.
This appliance is not intended for use by persons, including children, with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
! WARNING
Installation and maintenance should be performed by
qualified persons who are familiar with local code
and regulation, and experienced with this type of
appliance.
All field wiring must be installed in accordance with the
national wiring regulation.
Ensure that the rated voltage of the unit corresponds to
that of the name plate before commencing wiring work
according to the wiring diagram.
The unit must be GROUNDED to prevent possible
hazard due to insulation failure.
All electrical wiring must not touch the water piping or
any moving parts of the fan motors.
Confirm that the unit has been switched OFF before
installing or servicing the unit.
Risk of electric shock, can cause injury or death.
Disconnect all remain electric power supplies before
servicing.
DO NOT pull out the power cord when the power is
ON. This may cause serious electrical shocks which
may result in the fire hazards.
Keep the indoor and outdoor units, power cable and
transmission wiring, at least 1m from TVs and radios,
to prevent distorted pictures and static. {Depending on
the type and source of the electrical waves, static may
be heard even when more than 1m away}.

SAFETY PRECAUTIONS

Please take note of the following important points when
installing.
Do not install the unit where leakage of flammable gas
may occur.
Ensure that drainage piping is connected properly.
Do not overcharge the unit.
Ensure that the unit's panel is closed after service or
installation.
Sharp edges and coil surfaces are potential locations which
may cause injury hazards. Avoid from being in contact with
these places.
Before turning off the power supply set the remote controller's
ON/OFF switch to the "OFF" position to prevent the nuisance
tripping of the unit. If this is not done, the unit's fans will start
turning automatically when power resumes, posing a hazard to
service personnel or the user.
Do not install the units at or near doorway.
Do not operate any heating apparatus too close to the air
conditioner unit or use in room where mineral oil, oil vapour
or oil steam exist, this may cause plastic part to melt or deform
as a result of excessive heat or chemical reaction.
When the unit is used in kitchen, keep flour away from going
into suction of the unit.
This unit is not suitable for factory used where cutting oil mist
or iron powder exist or voltage fluctuates greatly.
Do not install the units at area like hot spring or oil refinery
plant where sulphide gas exists.
Ensure the color of wires of the outdoor unit and the terminal
markings are same to the indoors respectively.
IMPORTANT : DO NOT INSTALL OR USE THE AIR
CONDITIONER UNIT IN A LAUNDRY ROOM.
Don't use joined and twisted wires for incoming power
supply.
The equipment is not intended for use in a potentially explosive
atmosphere.
1-4
www.mrklimat.ru
! CAUTION
If gas leaks and accumulates around the unit, it may
cause fire ignition.
If the drainage piping is not connected properly, it may
cause water leakage which will dampen the furniture.
This unit is factory pre-charged. Overcharge will cause
over-current or damage to the compressor.
Unsecured panels will cause the unit to operate
noisily.
Тел.: 8-800-5555-710

Advertisement

Table of Contents
loading

Table of Contents