Status Leds; The Rear Panel; On/Off ("Reset") Switch; Power Socket - CNET CSH-24X2G User Manual

Port Type
Fiber 1000BASE-LX
1000BASE-SX
TP 100BASE-TX
10BASE-T

2.2.5 Status LEDs

This Switch comes with a complete range of LEDs. The table below lists each LEDs name, color
and a brief description of its function.
Name Color
PWR Green
Ports 1~24 Yellow(10Mbps)
LINK/ACT Green(100Mbps)
Ports 1~24 Green
FD/COL
Port 25,26 Green
Fiber
Ports 25,26 Green
FD
2.3

The Rear Panel

2.3.1 ON/OFF ("Reset") Switch

The power ON/OFF switch is located to the far right of the rear panel - next to the power
connector.
To reset the Switch, turn the power switch "OFF", then "ON".
Note: The Switch must be reset when the MAC address table needs to be rebuilt.

2.3.2 Power Socket

The Power Socket is designed to be used with the power cord included in the product package.
•Attach the female end of the power cord to the male power connector on the rear panel.
•Attach the male end of the power cord to a grounded power outlet.
Cable Type
9/125 μm Single-Mode fiber cable
50/125 μm Multi-Mode fiber cable
62.5/125 μm Multi-Mode fiber cable
50/125 μm Multi-Mode fiber cable
62.5/125 μm Multi-Mode fiber cable
Category 5 TP (Using min. 2 pairs)
Category 3, 4 or 5 TP
Function
Lit: Power "On"
Lit: When the port has a valid physical connection with
another device.
Blinks: When the port is sending or receiving data (Activity).
Lit: When the port is set to Full-Duplex mode.
Blinks: When a collision is detected in Half-Duplex mode.
Lit: When the port has a valid physical connection with
another device at 1000Mbps.
Blink: When the port is sending or receiving data (Activity).
Lit: When the port is set to Full-duplex mode.
Console
6
Connector
LC
LC
RJ-45
RJ-45
100-240V AC
50-60Hz
OFF ON