Power Adapter; Li-Ion Battery - TOOLCRAFT Digimicro LAB 3.0 Operating Instructions Manual

7.4 Power adapter

Do not tamper with power supply components. Risk of death by
electric shock!
Always ensure proper connection.
Never use damaged power supply components.
Do not modify power supply components.
Connect the appliance to a wall socket that can be accessed easily.
As power supply, only use the supplied mains adaptor.
Only connect the power adaptor to a normal mains socket connected to the
public supply. Before plugging in the power adaptor, check whether the volt-
age stated on the power adaptor complies with the voltage of your electricity
supplier.
Never connect or disconnect power adaptors if your hands are wet.
Never unplug the power adaptor from the mains socket by pulling on the cable;
always use the grips on the plug.
For safety reasons, disconnect the power adaptor from the mains socket during
storms.
Do not touch the power adapter if there are any signs of damage, as this may
cause a fatal electric shock! Take the following steps:
– Switch off the mains voltage to the socket containing the power adapter
(switch off the corresponding circuit breaker or remove the safety fuse, and
then switch off the corresponding RCD protective switch).
– Unplug the power adapter from the mains socket.
– Use a new power adapter of the same design. Do not use the damaged
adapter again.

7.5 Li-ion battery

The rechargeable battery is permanently built into the product and cannot be
replaced.
Never damage the rechargeable battery. Damaging the casing of the recharge-
able battery might cause an explosion or a fire!
28