Table of Contents
Advertisement
Shooting techniques for different targets (continued)
Marker
If you press the ZEBRA button while the zebra
pattern is being displayed, a marker appears in
the center of the display (if you have set the setup
menu, DISPLAY SETUP, MARKER to ON).
The brightness of the areas near the screen center
can be checked as a percentage (0% to 99%).
"99%↑" appears if the percentage is over 99.
Image level detection area
99%
Image level
The normal display reappears if you press the
ZEBRA button again.
Checking and displaying shooting status
DISP/MODE CHK button
During recording or while recording is paused, information
such as recording functions setting status and a list of
functions allocated to the USER buttons can be displayed
by keeping the DISP/MODE CHK button held down.
Release the button to return to the normal display.
Pressing the DISP/MODE CHK button during
recording or while recording is paused will
remove all displays from the screen except for the
operation status, frame display erea etc., counter,
marker, and safety zone display. Press the button
again to return to the normal display. (Page 50)
This setting will be maintained even if the camera's
power is turned off by moving the POWER switch to
the OFF position or if the operating mode is changed.
Pressing the DISP/MODE CHK button while the
thumbnail screen is displayed in PB mode will
display the properties of the selected clip.
(Clips can be selected by moving the cursor with
the Operation lever.)
6
Marker
MENU
EXEC
START/
PUSH-ENTER
STOP 2
–
+
AUDIO MON
MEGA
O.I.S.
ON
OFF
FOCUS
DISP/
POWER
. .
PUSH AUTO
FUNCTION
USER 1
MODE CHK
OFF
ON
CAM
MODE
A
M
PB
∞
CH1
AUDIO LEVEL
CH2
IRIS GAIN WHITE BAL
USER 2
L
B
M
A
H
PRST
PRE REC
Record video and audio from three seconds before
the time of the operation to begin recording.
Operation to start
recording
Actual recording
time
PRE REC time
1
Set the PREREC MODE item on the settings
menu RECORDING SETUP screen to ON.
PRE-REC will be displayed on the screen.
• When the TCG item on the TC/UB SETUP
screen has been set to REC RUN, the setting
will be automatically changed to FREE RUN.
2
Press the START/STOP button.
Video and audio from approximately 3 seconds
previously will be recorded.
• Recording of the previous 3 seconds of video
and audio may not be possible if recording is
started immediately in the following cases.
ā Immediately after switching from PB mode
to CAM mode
ā Immediately after turning power on
ā Immediately after changing to PREREC
MODE item
• The thumbnail for clips recorded using the
PREREC function will display the image from
when the START/STOP button was pressed.
Relay function
When the remaining space on an SD card is
insufficient during recording, recording can be
continued using the other SD card slot.
Select ON in the RELAY REC item on the settings
menu RECORDING SETUP screen.
• When the remaining space on an SD card is
insufficient during recording, recording will
automatically be continued using the SD card in
the other slot.
• The relay function is not available when an SD
card that cannot be recorded to is inserted in the
SD card slot.
• The camera is capable of continuous recording
for up to 12 hours maximum. This cannot be
extended even if the relay function is used.
Operation to stop
recording
(Time)
Advertisement
Table of Contents
