Dmx 512 Connection; System Menu - Beamz Double Helix 8x3W RGBW DMX Instruction Manual

DISPLAY
DMX-512 CONNECTION
If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the
first unit in a DMX chain. Always connect the output of one unit with the input of the next unit until all units are connected.
5-pin XLR DMX Connectors.
Some manufactures use 5-pin DMX-512 data cables for DATA transmission in place of 3-pin. 5-pin DMX fixtures may be
implemented in a 3-pin DMX line. When inserting standard 5-pin data cables in to a 3-pin line a cable adaptor must be used.
The chart below details a proper cable conversion.
3-Pin XLR to 5-Pin XLR Conversion
Conductor
Ground/Shield
Data Compliment (- signal)
Data True (+ signal)
Not Used
Not Used
At the last fixture, the DMX cable has to be terminated. Solder a 120 Ohm resistor between signal (-) and signal (+) into a 3-pin
XLR connector and plug this into the DMX output of the last fixture in the chain.

SYSTEM MENU

ADDR - DMX Address Setting.
1. Press the either the MENU, UP, or DOWN buttons until "ADDR"
is displayed, press ENTER.
2. The current address will now be displayed and flashing. Press the
UP or DOWN buttons to find your desired address. Press ENTER to
set your desired DMX address.
CHND - This will let select your desired DMX channel
mode.
1. Press the MENU button until "CHND" is displayed, press ENTER.
The current DMX channel mode will be displayed
2. Press the UP or DOWN buttons to find your desired DMX channel
mode and press ENTER to confirm and exit.
4
The control board offer several features: you can simple set the starting
address, run the pre-programmed program or make a reset. The main menu is
accessed by pressing the Mode-button, browse through the submenu by
pressing Up or Down.
Press the Enter-button in order to select the desired menu.
You can change the selection by pressing Up or Down. Confirm every selection
by pressing the Enter-button.
You can leave every mode by pressing the Mode-button. The functions
provided are described later in this manual.
3-Pin XLR Female (Out) 5-Pin XLR Male (In)
Pin 1 Pin 1
Pin 2 Pin 2
Pin 3 Pin 3
Pin 4 – Do Not Use
Pin 5 – Do Not Use
ENTER ENTER
MODE MODE
UP
DOWN
ENTER
MODE
UP
DOWN
UP
DOWN
UP
DOWN
UP
DOWN
UP
DOWN
UP
DOWN