Advertisement
Step 1
B14 ctr
(8)
The front fl oor frame is made up of
three pieces. The rear fl oor frame is
made up of two pieces. The holes
in these pieces will align when the
pieces are positioned with correct
amount of overlap. The illustrations
below show the proper overall length
for the front and rear. Proceed as
follows:
1
Place the front fl oor frames as
shown. Center the ramp, with drain
holes facing outside, on top of the two
front fl oor frames. Join the frames by
inserting eight screws.
2
Overlap the rear fl oor frames as
shown. The holes in these pieces will
align when the pieces are positioned
with correct amount of overlap. See
the illustrations below for the proper
overall length of the rear fl oor frame.
Join the frames by inserting fi ve bolts
into frame set as shown.
3
Double check the length of each
and set these pieces aside for later
use.
Parts Needed For
Floor Frame Assemblies
(5)
STEP
3
9379
8941
STEP
1
9379
DRAIN HOLES FACE
OUTSIDE
STEP
2
9377
14
8941 Ramp (1)
9379 Front Floor Frame (2)
9377 Rear Floor Frame (2)
9379
Frame Assembly
8941
95 7/8" 243,5 cm
9379
Rear Floor Frame
95 7/8" 243,5 cm
95 7/8" 243,5 cm Rear
95 7/8"
243,5 cm
9377
Front Floor
9377
Front
Advertisement
