Table of Contents
Advertisement
The integrated peripheral controller contains an IDE interface with support for two IDE
channels. Select Enabled to activate each channel separately. The settings are: Enabled and
Disabled.
Primary/Secondary Master/Slave PIO
The four IDE PIO (Programmed Input/Output) fields let you set a PIO mode (0-4) for each of
the four IDE devices that the onboard IDE interface supports. Modes 0 through 4 provide
successively increased performance. In Auto mode, the system automatically determines the
best mode for each device. The settings are: Auto, Mode 0, Mode 1, Mode 2, Mode 3, Mode
4.
Primary/Secondary Master/Slave UDMA
Ultra DMA/33 implementation is possible only if your IDE hard drive supports it and the
operating environment includes a DMA driver (Windows 95 OSR2 or a third-party IDE bus
master driver).
If your hard drive and your system software both support Ultra DMA
33/66/100, select Auto to enable BIOS support. The settings are: Auto, Disabled.
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple sector read/write. If
your IDE hard drive supports block mode (most new drives do), select Enabled for automatic
detection of the optimal number of block read/writes per sector the drive can support. The
settings are: Enabled, Disabled.
3-7-2 OnChip SIO Function
CMOS Setup Utility – Copyright(C) 1984-2000 Award Software
Onboard FDD Controller
Onboard Serial Port 1
Onboard Serial Port 2
UART 2 Mode
IR Duplex Mode
TX,RX inverting enable
Onboard Parallel Port
Onboard Parallel Mode
Parallel Port EPP Type
ECP Mode Use DMA
↑↓→← Move Enter:Select Item +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values
Onboard FDD Controller
OnChip SIO Function
Enabled
Auto
Auto
Normal
Half
No, Yes
378/IRQ7
Normal
EPP1.9
3
F6:Optimized Defaults
32
Item Help
Menu Level >>
F1:General Help
F7:Standard Defaults
Advertisement
Table of Contents
