Factair F4504 Operating Manual page 44

Multi-air tester

Table of Contents

Compressed air

2. Compressed air for BA normally originates from a compressor system. The maintenance,

examination and testing of compressors should be carried out according to the manufacturer's

instructions. The siting of air inlets to compressors should follow the same principles as for

fresh air hose. However, because compressors themselves can generate and concentrate a

wide range of contaminants, you should take extra care in assuring air quality.

3. As the BA wearer's life and health depend on the air supplied by the compressor, you should

ensure that the air supplied meets the quality requirements in British Standard BS EN 12021

Respiratory protective devices. Compressed air for breathing apparatus,* in addition to the

pressure and airflow rate requirements of the BA manufacturer.

4. Compressors which are moved from site to site, such as those used by the emergency services

or on construction sites, will require a higher standard of maintenance and should be sited so

that the quality of air they provide is not compromised by nearby contaminants.

* BS EN 12021 states: 'Compressed air for breathing apparatus shall not contain any contaminants at

a concentration which can cause toxic or harmful effects. In any event all contaminants shall be kept

to as low a level as possible and shall be far below the national exposure limit. Combination effects of

more than one contaminant shall be taken into account.' (1999)Respiratory protective equipment at

work Page 48 of 59

Periodic testing of air quality

5. The purpose of periodically testing air quality is to make sure that the control measures you

have put in place are delivering the air quality required by BS EN 12021. You should base the

frequency of such tests on a risk assessment, but they should take place at least every three

months, and more often when the quality of air cannot be assured to these levels.

6. As part of the risk assessment, if a mobile compressor is being used consideration should be

given as to how often the air supply should be checked when the compressor is moved. Testing

for these components may be carried out using any appropriate method, eg:

simple colour change tubes;

on-line gas testers;

sample collection for laboratory analysis elsewhere.

7. The supplier of your compressor or BA should be able to advise you on the best method for

you. You should keep records of air quality tests for five years.

for Scotland.

Source Acknowledgement:

HSG53 Respiratory Protective Equipment at Work ISBN 978 0717 6454 2 Health and Safety Executive 2013

Contains public sector information licensed under the Open Government Licence v3.0

Table of Contents