Table of Contents
Advertisement
USING THE LCD DISPLAY
3.5.2
PIP Swap
The main and the sub source signals set in PIP Setting can be easily
swapped using the keypad.
Main source
q
Touch the
button to swap the main source and the sub source
signals. See illustration below.
Main source
3.6 Using Auto Adjustment Function
Auto Adjustment function automatically tunes the LCD display to its
optimal setting, including horizontal position, vertical position, clock,
and phase.
Touch the
button to perform auto adjustment.
The message auto adjusting is displayed on the screen.
During auto adjustment, the screen will slightly shake for a few
seconds.
When the message disappears, auto adjustment is completed.
A U T O
A D J U S T I N G
Note:
Sub source
♦
PIP Swap can only be executed
if PIP is enabled, see page 34.
Sub source
Note:
♦
Auto Adjustment function is
available only during VGA input
signals.
♦
It is recommended to use the
auto adjustment function when
using the LCD display for the
first time or after a resolution or
frequency change.
20
Advertisement
Table of Contents
