Part Names And Functions Of The Remote Controller - Toshiba MMD-VNK802HEXE Owner's Manual

Air to Air Heat Exchanger with DX Coil Unit
4
Part Names and Functions of the Remote
Controller
Remote controller for the Air to Air Heat Exchanger with DX Coil
Unit (NRC-01HE)
◆ Operation section
• One of these remote controllers can be used to control both indoor air
conditioner units and Air to Air Heat Exchanger with DX Coil Units (up to 8
units in total).
• After setting the operation conditions, you can use the units by just pressing
the ON/OFF button.
• Functions concerning controlling the Air to Air Heat Exchanger with DX Coil
Unit are explained here. For controlling an air conditioner, refer to the
owner's manuals supplied with the remote controller and the air conditioner.
2
5
3
1
button (Fan speed select button) (*1)
2
button (Timer set button)
Used for timer setting
3
button (Test button)
Used for service.
Do not use this button in everyday operations.
4
button (*1) (Ventilation button)
This button is used when the Air to Air Heat
Exchanger with DX Coil Unit is in a system linked
with air conditioners. Push the button to turn
on/off the Air to Air Heat Exchanger with DX Coil
Unit. Turning on/off the air conditioner also turn on/
off the Air to Air Heat Exchanger with DX Coil Unit.
11-EN
Owner's Manual
Display
section
Operation
section
1
4
6
* No Air to Air Heat Exchanger with DX Coil
Unit is connected or separate operation of the
Air to Air Heat Exchanger with DX Coil Unit is
not set, if " " appears on the remote
controller display after pushing the
button.
5
button (Filter reset button)
Resets " FILTER" indication after cleaning.
6
button (Power save operation)
Use to initiate power saving mode.
Air to Air Heat Exchanger with DX Coil Unit
12
15
14
7
SWING/FIX button (Swing/Louver direction
button) (*1)
8
Operation lamp
Lights up during operation.
Blinks when an error occurs or the protective
device activates.
9
button
Turns on the unit when pressed, and turns it off
when pressed again.
10
button (Operation mode select button)
Selects desired operation mode.
11
UNIT LOUVER button (Unit select button)
Used for selecting a unit while changing settings if
the remote controls two or more units.
12
button (Temperature set button)
Adjusts the set temperature.
Select the desired set point by pushing
or TEMP.
– 6 –
8
13 7 11
13
button (Ventilation fan speed button)
Used to select the ventilation fan speed
14
button (Ventilation mode button)
Used to select a ventilation mode.
15
button (Filter elevating button) (*1)
16
UNIT LOUVER
button (Louver select button) (*1)
OPTION:
Remote controller sensor
Normally the temperature sensor of the indoor unit
senses the temperature. The temperature around the
remote controller can also be sensed. For details,
contact your dealer.
* Do not use the function when the air conditioner is
controlled in a group.
(*1):
This function is not available for Air to Air Heat
TEMP.
Exchanger with DX Coil Unit.
" " will be displayed for few seconds when the unit is
running in a system equipped with only the Air to Air
Heat Exchanger with DX Coil Unit.
Owner's Manual
9
10
16
EN
12-EN