Hoover HLSI 550GT User Instructions page 13

The dishwasher is able to signal a series of faults in the display.
AUTOMATIC FAULT SIGNALS
FAULTS
E2 No water (inlet hose closed).
appears on the display and
the alarm sounds.
E3 The machine cannot drain water.
appears on the display and
the alarm sounds.
E4 Water leak
appears on the display and
the alarm sounds.
E5,E6,E7,Ef EL Electronic control fault.
or appears
on the display and the alarm
sounds.
E8 Ei The water heating element is not
or appear on the display
working correctly or the filter plate is
and the alarm sounds.
clogged.
CAUSE SOLUTION
Turn off the dishwasher, open the
inlet hose and reset the cycle.
Check if the drain tube is bent or if
the siphon or filters are clogged.
If the problem persists, contact
Customer Service.
Check if the drain tube is bent or if
the siphon or filters are clogged.
If the problem persists, contact
Customer Service.
Contact Customer Service.
Clean the filter plate.
If the problem persists, contact
Customer Service.
24
WATERCONTROL-SYSTEM
The water-stop device protects against water damages caused by leaks on the fill
hose which could develop due to natural ageing of the hose.
In the water-stop system the leaking water fills the corrugated hose and activates a
stop valve which cuts off the water supply to the machine.
This fault is shown by a red sector on the window «A».
Would this occur, please refer to your Service Agent.
If the hose is not long enough for correct connection, it must be replaced with a longer
one. The hose can be obtained from your Service Agent.
Safety antitwist device
(press and twist to
remove the washer)
A
Red button blocked
valve indicator
25