Daily Use - Washing & Drying - Zanussi Z816WT85BI User Manual

END OF THE PROGRAMME
When the programme has finished, the appliance
stops automatically. The acoustic signals operate (if
they are active). The display shows
The indicator of the Start/Pause
off.
The door unlocks and the indicator
1. Press button On/Off to deactivate the
appliance.
After five minutes from the end of the programme,
the energy saving function automatically
deactivates the appliance.
When you activate the appliance
again, the display shows the end of
the previous programme. Turn the
programme dial to set a new cycle.
2. Remove the laundry from the appliance.
3. Make sure that the drum is empty.
4. Keep the door and the detergent dispenser
slightly ajar to prevent mildew and odours.
5. Close the water tap.
DRAINING WATER OUT AFTER END OF
CYCLE
If you have chosen a programme or an option that
does not empty out the water of the last rinse, the
programme is completed, but:
• The time area shows
shows the door locked
• The indicator of the Start/Pause
starts flashing.
• The drum still turns at regular intervals to
prevent creases in the laundry.
• The door stays locked.
• You must drain the water to open the door:
DAILY USE - WASHING & DRYING
WARNING! Refer to Safety chapters.
This appliance is an automatic washer
dryer.
button goes
goes off.
and the display
.
button
1. If necessary, touch the Spin button to decrease
the spin speed proposed by the appliance.
2. Press the Start/Pause
appliance drains the water and spins.
The option indicator Rinse Hold
If you have selected No Spin
the appliance will only drain the water.
3. When the programme is completed and the
door locked indicator
open the door.
4. Press the On/Off button for a few seconds to
deactivate the appliance.
STAND-BY FUNCTION
The Stand-by function automatically deactivates the
appliance to reduce the energy consumption when:
• You do not use the appliance for 5 minutes
when no programme is running.
Press the button On/Off to activate the
appliance again.
• 5 minutes after the end of the washing
programme.
Press the On/Off button to activate the
appliance again.
The display shows the end of the last
programme.
Turn the programme dial to set a new cycle.
If the dial is rotated to the "Reset" position
appliance automatically turns off in 30 seconds.
If you set a programme or an option
that ends with water in the drum, the
Stand-by function doesn't
deactivate the appliance to remind
you to drain the water.
COMPLETE WASH&DRY PROGRAMME
Automatic Non-Stop programme or
programmes
Depending on the model, the appliance may be
equipped with one or more NonStop 60min
programmes, automatic wash&dry programmes
where it is not necessary to set the Mode - Dry.
Proceed as follows:
1. After loading laundry and detergent, press the
On/Off button for some seconds to activate the
appliance.
button: the
disappears.
,
goes off, you can
, the
29