Table of Contents
Advertisement
Use the hose supplied with appliance.
Do not use an extension hose if the inlet hose is too short. Contact the Authorised Service
Centre for an inlet hose replacement.
Water drainage
The drain hose can be connected:
10
Ø 40 mm
5. Connect the water inlet hose to the cold water tap
with 3/4 thread.
WARNING! Make sure that there are no
leaks from the couplings.
To a stand pipe with vent-hole
Directly into a drain pipe at a height of not less than
60 cm (23.6") and not more than 100 cm (39.3").
The end of the drain hose must always be ventilated ,
i.e. the inner diameter of the drain pipe (min. 40 mm -
min. 1.6") must be larger than the external diameter
of the drain hose.
To a sink spigot
Put the drain hose in the spigot and tighten it with
the supplied cable tie L.
Make sure that the drain hose makes a loop to pre-
vent particles going into the appliance from the sink.
Advertisement
Table of Contents
