Table of Contents
Advertisement
Problem
There is water on the floor.
You cannot open the appli-
ance door.
The appliance makes an
unusual noise and vibrates.
The programme duration
increases or decreases
during programme execu-
tion.
The washing results are
not satisfactory.
Too much foam in the
drum during the washing
cycle.
After the washing cycle,
there are some detergent
residues in the dispenser
drawer.
The appliance does not dry
or does not dry correctly.
The laundry is full of differ-
ent colours fluff.
40
•
Make sure that the couplings of the water hoses are tight and there
is not water leakages.
•
Make sure that the water inlet hose and the drain hose have no
damages.
•
Make sure you use the correct detergent and the correct quantity of
it.
•
Make sure that a washing programme that ends with water in tub,
has been selected.
•
Make sure that the washing programme is finished.
•
Set the drain or the spin programme if there is water in the drum.
•
Make sure that the appliance receives electrical power.
•
This problem may be caused by a failure of the appliance. Contact
the Authorised Service Centre.
If you need to open the door, please read carefully "Emergency
door opening".
•
Make sure the levelling of the appliance is correct. Refer to "Instal-
lation instruction".
•
Make sure that the packaging and/or the transit bolts are removed.
Refer to "Installation instruction".
•
Add more laundry in the drum. The load may be too small.
•
The AutoAdjust System is able to adjust the programme duration
according to the type and the laundry load size. Refer to "The Au-
toAdjust System load detection" in "Daily Use" chapter.
•
Increase the detergent quantity or use a different detergent.
•
Use special products to remove the stubborn stains before you
wash the laundry.
•
Make sure that you set the correct temperature.
•
Decrease the laundry load.
•
Reduce the quantity of detergent.
•
Make sure that the flap is in the correct position (UP for powder
detergent - DOWN for liquid detergent).
•
Make sure you have used the detergent dispenser according the
indications given in this user manual.
•
Turn the water tap on.
•
Make sure the drain filter is not clogged.
•
Reduce the laundry load.
•
Make sure you have set the correct cycle. if necessary, set again a
short drying time.
The fabrics washed in the previous cycle released fluff of a different
colour:
•
The drying phase helps to eliminate some fluff.
•
Clean the clothes with a fluff remover.
In case of an excessive amount of fluff in the drum run the special pro-
gramme to clean it (refer to "Fluff in the fabrics" for more details).
Possible solution
Advertisement
Table of Contents
