Table of Contents
Advertisement
Operation
Switching Touch Operation Panel Display
Use this to adjust the unit to your preferred setting.
Long-press
display
Dimmer
Type 1/2/Off
The touch operation panel display will switch at each press.
Display 1
If the lights in the touch operation panel display are turned off, tap the
played.
(Tapping the
Operation Panel
Display
Select operation mode and airflow rate by
tapping the panel.
For power saving, the display and operation
Display 1
panel other than the notifi cation display and
the air sensor will turn off approximately one
minute after the unit stops operating.
When all indicators are on, tapping the op-
eration panel and selecting operation mode,
airfl ow rate or other similar buttons will make
the display light of the selected buttons
Display 2
brighter.
* The display may not be clear to look at
Display is the same as Display 1.
The display, operation panel, notifi cation dis-
Off
play, and clean monitor go off approximately
one minute after the unit stops operating.
In this instruction manual, the following examples are described in Display 1.
E-20
(Continued)
Display
for about 3 seconds and select touch operation panel
·
Display 2
Off
again turns off the indicator of the touch operation panel display.)
Display Contents of the Operation Panel
Display Contents
when the unit is placed near windows with
direct sunlight, and other similarly bright
places.
(When switching from Off to Display 1, the buzzer will ring twice
(beep, beep) and the display will blink once. )
and operate after the panel is dis-
Example
(When selecting Air Purify / Max)
(When selecting Air Purify / Max)
(When indicators are dimmed)
Advertisement
Table of Contents
