Advertisement
Contents
Connections
Speaker connection
Here we connect the speakers in the room to this unit.
This section explains how to connect them using typical examples.
NOTE
0 Disconnect this unit's power plug from the power outlet before connecting the
speakers. Also, turn off the subwoofer.
0 Connect so that the speaker cable core wires do not protrude from the speaker
terminal. The protection circuit may be activated if the core wires touch the rear
panel or if the + and - sides touch each other. ("Protection circuit" (v p. 74))
0 Never touch the speaker terminals while the power cord is connected. Doing so
could result in electric shock.
0 Use speakers with an impedance of 6 – 16 Ω/ohms.
Connecting the speaker cables
Carefully check the left (L) and right (R) channels and + and – polarities on
the speakers being connected to this unit, and be sure to connect the
channels and polarities correctly.
1
Peel off about 10 mm of sheathing from the tip of the
speaker cable, then twist the core wire tightly.
Front panel
Display
Playback
.
Rear panel
Settings
2
Turn the speaker terminal counterclockwise to loosen
it.
3
Insert the speaker cable's core wire to the hilt into the
speaker terminal.
4
Turn the speaker terminal clockwise to tighten it.
18
Remote
Tips
Appendix
.
.
.
Index
Advertisement
