Table of Contents
Advertisement
Horizontal Rotator
1
IR LED
2
Vertical Rotator
3
Lens Rotator
4
Lens
5
Power
6
Camera Installation
Installation
• Check the wall or ceiling to see if it needs to be
reinforced. The camera may fall off if the wall
or ceiling is not strong enough to support its
weight.
• Install the camera in a shaded area. If the camera
is installed in direct sunlight, it may be affected
adversely.
1
Hold the camera body and dome cover and turn
the dome cover clockwise to remove the dome
cover from the camera body as follows:
Network Camera
Network Port
7
Cable Rubber
8
Video Out
9
Factory Reset Switch
0
SD Memory Card Slot
!
Alarm I/O, Audio I/O
@
2
Insert a SD memory card into the SD memory card
slot with the 'micro SD' print facing upward.
Push the SD memory card until it disengages from
the slot, and then pull it out.
microSD Logo is a trademark of SD-3C, LLC.
3
Remove the ceiling tile from the ceiling. Draw
circle on the tile by using the mounting template
provided with the camera. Cut the circle out of the
ceiling tile.
Ceiling
4
Connect external devices, the network cable, and
the power adapter. Block the cable access hole to
prevent foreign substance from entering by using
the enclosed cable access hole rubber or pipe (NPT
3/4") when routing cables and wires.
5
Adjust the angle of the lens. For more information,
refer to the Angle Adjustment.
Guide pattern
Center
5
Advertisement
Table of Contents
