Baileigh Industrial RDB-150-AS Operator's Manual page 42

Material slips in the hookarm
Spindle drive pins are damaged
Poor Bend Results
Too much lube on material and is transferring to the bend
die clean the bend die with degreaser.
The counter die should be lubed only
The material may need to be clamped
Wrong material for the die set
If the bend dies are not bolted down properly the drive pins
will get damaged. Replace drive pins.
Check proper tooling for material IE Pipe Vs Tube. Green
for pipe, Blue for tube, Red for metric and Gray for square
or rectangle tubing. See pipe sizing chart
Wall thickness is too thin
39
39