Baileigh Industrial RDB-150-AS Operator's Manual page 27

Using the auto stop feature – if equipped, (Setting the automatic stop position)
The cylinders must be fully retracted and the main (top) degree dial must read "0" deg before
setting the lower degree dial.
Note: Do not adjust the micro switch mounting bracket; this is preset from the
factory. Use only the black Autostop adjusting knob (A) to adjust the dial.
1. Method #1: Using the lower degree dial, set
the lower pointer to the desired degrees by
loosening the black knob (A) and rotating the
degree dial until the desired bend angle plus
spring back is displayed (B).
2. Example: 105deg = 100deg bend, 5degrees
of spring back.
3. Method #2: You can set the lower degree dial
after a bend is complete also.
Example: Bend a piece of material to a
desired angle using the top degree dial only.
Once you are at the final bend position, Stop with
the material still in the machine. Loosen and rotate
the lower degree dial to "0" degrees (B). You will
feel a definite click latching the dial in position; this
is the spring-loaded micro switch (C) holding the dial
in position.
Note: The auto-stop feature only functions
properly when the machine is bending material. The
system needs pressure to function. You will not
damage anything by running without material, as the
micro switch is activated by the degree dial. The machine will hesitate and then continue but will
not stop unless you are bending material.
4. If the lower degree dial is set and the desired angle is more or less degrees than planned /
calculated for, simply advance or retard the lower degree dial to compensate for the
difference.
24
24
A
C
B