Step 17 Connect Drain Line - Monogram ZDT870SPFSS Installation Instructions Manual

STEP 17 CONNECT DRAIN LINE

The molded end of the drain hose will fit 5/8" through 1"
diameter inlet ports on the air gap, waste tee or disposer.
• Determine size of inlet port.
• Cut drain hose connector on the marked line, if required, to
fit the inlet port.
Cutting Line
1"
IMPORTANT: Do not cut corrugated
Figure Z
• If a longer drain hose is required and you did not purchase
drain hose WD24X10065, add up to 66" length for a total of
144" (12 feet) to the factory-installed hose. Use 5/8" or 7/8"
inside diameter hose and a coupler to connect the 2 hose
ends. Secure the connection with hose clamps.
Figure AA
NOTES:
• DRAIN CONNECTION HEIGHT IS NOT TO EXCEED 72"
ABOVE BOTTOM OF DISHWASHER.
• TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED 12
FEET FOR PROPER DRAIN OPERATION.
Dishwasher Installation
5/8"
portion of hose
STEP 17 CONNECT DRAIN LINE (CONT.)
• Connect drain line to air gap, waste tee or disposer using
the previously determined method. Secure hose with a
screw-type clamp.
Method 1 – Air gap with waste tee or disposer
Waste Tee Installation
Method 2 – "High drain loop" with waste tee or disposer
With this method you will need the drain hose hanger set
aside in Step 1.
Fasten drain hose to underside of countertop with the pro-
vided hanger.
Drain Hose Hanger
18"
Min.
Waste Tee Installation
IMPORTANT –
to disposer, check to be sure that drain plug has been
removed. DISHWASHER WILL NOT DRAIN IF PLUG IS LEFT
IN PLACE.
Tip: Avoid unnecessary service call charges for a
no drain complaint.
Make sure excess drain hose has been pulled through
the cabinet opening. This will prevent excess hose in the
dishwasher cavity from becoming kinked or crushed by the
dishwasher.
13
Disposer Installation
Figure AB
32"
Min.
Disposer Installation
Figure AC
When connecting drain line
Remove
Drain
Plug
32"
Min.
18"
Min.