Step 23 Replace Toekick; Step 24 Check The Following - Monogram ZDT870SPFSS Installation Instructions Manual

STEP 22 POSITION INSULATION, PRE-
TOEKICK, AND SOUND
BARRIER
(CONT.)
• Locate the control box.
• Push insulation block portion under the dishwasher until it
is beneath the control box.
(on some models)
• Push the panel portion up to the front of the block.
Push the sides of the insulation behind
the toekick attachment screw holes
• Tuck the sides of the front panel behind the toekick
attachment screw holes.
• Open door all the way, if the door doesn't stay fully open,
adjust the insulation panel.
• On models so equipped, position pre-toekick over the
insulation. Align the screw holes with the screw holes on
the legs of the dishwasher.
NOTE: While performing installations described in this book,
safety glasses or goggles should be worn.
For Monogram local service in your area, call
®
1.800.444.1845.
NOTE: Product improvement is a continuing endeavor at
General Electric. Therefore, materials, appearance and
specifications are subject to change without notice.
GE Appliances
General Electric Company
Louisville, Kentucky 40225
Monogram.com
Dishwasher Installation
(on some models)
Control Box
Figure AG
Figure AH

STEP 23 REPLACE TOEKICK

• Place toekick against the pre-toekick and legs of the
dishwasher.
Figure AJ
• Align the toekick with the bottom edge and make sure it is
against the floor.
• Insert and tighten the 2 toekick attachment screws. The
toekick should stay in contact with the floor.
• When reinstalling the toe kick on models with a sound
barrier, ensure that the bottom edge of the rubberized flap
is flush with the floor. Any excess material should be tucked
up behind the outer door. Do not allow excess rubberized
flap to lay on the floor. If any excess is not tucked completely
behind the outer door, it will bunch up between the door and
toe kick and impede proper opening and closing of the door.
This will be noticeable because the door will not stay fully
open and will spring up.
Tip: Reduce sound from under the dishwasher. Make sure
toekick is against floor.

STEP 24 CHECK THE FOLLOWING

• Tub trim does not interfere with the door
• Dishwasher is square and level at both the top and
bottom of the cabinet opening, with no twisting or
distortion of the tub or door
• All 4 legs of the dishwasher are firmly in contact with
the floor
• Drain hose is not pinched between the dishwasher and
adjacent cabinets or walls
• Tub trim is fully seated on the tub flange
STEP 25 LITERATURE
• Be sure to leave complete literature package, these Installation
Instructions and product samples and/or coupons with the
consumer.
T o e k i c k
Attachment
Screws