Campania International Aurelia FT-283 Assembly Instructions

Fountain Components
Image
Fountain Water
Assembly & Installation - A fountain can be diffi cult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
Fountain Information:
• This fountain holds approximately 5 gallons of water.
• This fountain uses a small fountain cover: FTNCOV-SM
• Compatible with Refi ll #10 Device
• (A special stopper is required to use the refi ll kit for this fountain)
Pump Information:
OEMPF140 - 140 GPH Pump 6 FT cord length
Tools Required:
Bubble Level
Screwdriver
Component
Item Description Quantity
Item #
Aurelia
FT-283A
Feature
Williamsburg
Chiswell FT-283D
Fountain Urn
Williamsburg
Chiswell
FT-283E
Fountain
Pedestal
Fountain Set-Up:
Image
1
1
1
FT-283 Aurelia Fountain
Assembly Instructions
Pump Kit Parts List
Component
PK140 Pump
(use only large adapter)
#10 Stopper
Approx. 12" length of 1/2" black
non-kink tubing
Approx. 2" length of 5/8" clear vinyl
tubing
Approx. 2" length of CPVC pipe
Wedges
Hose Clamps
Proudly
MADE IN USA
Quantity
1
1
1
1
1
3
1
rev 4/24/2020