Campania International FT-284 Assembly Instructions

Download this manual

FT-284 Polamar Fountain

(5 Pieces)

Components and Parts List

FT-284A

15"x15"x .75"

12lb

FT-284B

24"x24"x20"

170lb

FT-284C

15"x15"x7"

22lb

FT-284D

6.5"x6.5"x1.25"

4lb

12" length ½" non-kink hose (1)

Wedges (3)

Hose clamps (3)

Note: Hose clamps can be used

as flow restrictors

500 GPH Pump (1)

FT-284E

Putty (1)

45"x45"x10"

#10 Stopper (1)

417lb

3/4" barb to ½" Connector

Pump Kit Parts List

Revised July 12, 2016

Tools Required

Level

This Fountain uses

FTNCOV-MED

Page 1 FT-284 Polamar Fountain (5 Pieces) Revised July 12, 2016 Components and Parts List FT-284A 15”x15”x .75” 12lb FT-284B 24”x24”x20” 170lb FT-284C 15”x15”x7” 22lb FT-284D 6.5”x6.5”x1.25” Tools Required Pump Kit Parts List 12” length ½” non-kink hose (1) Level Wedges (3)
Page 2 FT-284 Palomar Fountain (5 pieces) Revised July 12, 2016 ASSEMBLY INSTRUCTIONS 1. Make sure you are assembling your fountain on a level surface capable of holding a minimum of 500 pounds with approximately an 8 square foot footprint. 2. Place the Basin (FT-284E) into position where the fountain will be installed.
Page 3 - G E N E R A L F O U N T A I N T I P S - Install fountains on a level surface. You will need a properly grounded 110-volt (AC only) GFCI protected receptacle near the fountain for your pump. All pumps are submersible and must be completely underwater to function properly.