Summary of Contents for Campania International FT-286
Page 1
FT-286 Falling Water I Fountain Assembly Instructions Fountain Information: • This fountain holds approximately 20 gallons of water. • This fountain uses a large fountain cover: FTNCOV-LG • Compatible with Refill Device and LED kits • A special stopper is not required to use the refill kit for this fountain Pump Information: OEMPF525 - 525 GPH Pump (16 ft.
Page 2
FT-286 Falling Water I Fountain Assembly Instructions Two people are recommended for the installation of this fountain! Fountain Set-Up: Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is installed properly, please read our instructions and tips before you begin.
Page 3
FT-286 Falling Water I Fountain Assembly Instructions Step 7 - Place the water feature (FT-286A) on top of the pump cover (FT-286C) and ensure that the pump cord exits through the hole provided. Step 8 - Insert the 2" CPVC end of the tubing assembly into the coupling protruding from the bot- tom of the water feature (FT-286A).
Page 4
Maintenance: Pump Care - The fountain relies heavily on the quality of the pump. A well-maintained pump can last several years. Step 1 - Fully submerge: Ensure the pump is fully submerged at all times to avoid damage. Step 2 - E nsure water level is sufficient: Check water levels regularly as water may evaporate over time, and periodically change water to avoid algae buildup.