2.7.1.1
Typical current profiles
The typical 5V startup and operation current profile is shown in
Figure 1
Typical 5V Startup and Operation Current Profile
2.7.2
Conducted noise
Input noise ripple is measured at the host system power supply across an equivalent 15-ohm resistive load on the +5 volt line.
Using 5-volt power, the drive is expected to operate with a maximum of 100 mV peak-to-peak square-wave injected noise at up to 20 MHz.
Equivalent resistance is calculated by dividing the nominal voltage by
Note
the typical RMS read/write current.
2.7.3
Voltage tolerance
Voltage tolerance (including noise):
+5V ± 5%
Seagate Video 2.5 HDD Product Manual, Rev. J (Draft 1)
Figure
1.
Drive Specifications
11