Basic Function; Demonstration Mode; Switching The System On; Switching The System To Standby Mode - Kenwood M-707i-B Instruction Manual

Basic function

Demonstration mode

The system is equipped with a demonstration
function (only display). When the power cable is
plugged in and button is pressed to turn the
system on for the fi rst time, the demonstration
automatically starts. The demonstration consists of
sequential change of display and indicators showing
the operations, but the audio itself does not change.
The demonstration function can be cancelled as
follows.
To deactivate the demonstration
Press [demo] button on the main unit during
demonstration.
To activate the demonstration
After turning the power on, press [demo] button on
the main unit.
⁄
• The demonstration operates automatically when; a power has
failed and then recovered, or the plug of the power cable has
been pulled out while the power was on and then plugged
back in.

Switching the system on

Press [ ], CD/USB [CD/USB], TUNER band
[TUNER band], TAPE mode [TAPE mode], iPod [iPod]
button.
The [standby] LED will go out.
The system will switch to the last selected source or
the selected source.

Switching the system to standby mode

Press [ ] button.
[standby] indicator is lit.
12
M-707i

Volume control

Press VOLUME 5 (turn [volume] knob to the right)
button to increase, or press VOLUME ∞ (turn
[volume] knob to the left) to decrease the volume
level.
"VOL XX" is displayed. "VOL XX" denotes the volume
level.
To switch off the volume temporarily
Press MUTE button.
Playback continues without sound, and "MUTE" is
displayed.
⁄
• To restore the volume, press MUTE button again or adjust the
volume.

Sound control

The sound control system feature enables you to
enjoy special sound eff ects; preset equalizer settings
and bass enhancement, providing the best music
reproduction.
To switch on preset equalizer settings
Press EQ [EQ] button to select the desired sound
eff ect: POP, CLASSIC, ROCK, JAZZ or FLAT (off ).
When an eff ect other than FLAT is selected, the "EQ"
icon appears on the display.
To switch on the bass enhancement
Press X-BASS [X-bass] button.
The icon "X-BASS" appears on the display.
⁄
• To switch off X-BASS, press X-BASS [X-bass] button. The icon
"X-BASS" disappears.
• EQ and X-BASS functions are not applied to the recording
sound.

Headphones

To listen to your stereo with headphones (separately
available), use the 3.5 mm phones jack on the main
unit.
¤
• Excessive sound pressure from earphones and headphones
can cause hearing loss.